Fluid Power Journal

DIN 24342 Proportional Flow Control (5000 psi)

This proportional control valve comes in sizes from 16 to 50mm and fits standard ISO 7368 and DIN 24342-cavity porting.  Control areas provide 4 millisecond response time and can close the poppet under a high-pressure load.  The valve has On Board Electronics. All you need to provide is a 0-10-volt command, which is proportionate to the position of the valve. No additional Amplifier Card is needed.   The valve requires a 24-volt supply with a minimal electrical current of 3 amps per valve. It also requires a minimum pilot pressure of 40 psi. If voltage or pressure drops below the minimum requirement, the valve shifts closed to safe mode.

Share this information.

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

Sponsor

Sponsors


Get Our E-News!