Fluid Power Journal

Intake Filter in a Mansion Elevator

A well-known actor had a small elevator installed in his mansion that sits on top of a Tennessee mountain. He wanted it to lift two people up 20 feet to a roof-top balcony. Since there was not a roof to mount the typical electric drum and drive, a hydraulic lift was installed. The circuit was simple, using a vane pump running at 1200 RPM to keep the noise level to a minimum.

The hydraulic system was designed so the maximum pump flow determined the lifting speed and a flow control determined the lowering speed. The control system was designed to use 24 VDC with a battery backup in case of a power failure. Since the valve was directly operated, battery power could be used to shift the valve and lower the elevator down from the roof top. It is questionable if the designed circuit met all state and local safety standards.

After a year or so, each time the unit was started, it rumbled for about two minutes and then settled down to a normal running sound. The system designer was nowhere to be found, so a local repair shop was contacted. The employee concluded the unit was losing its prime. Since there were no signs of external leakage where the air could be getting in, the repair shop employee convinced the owner that a check valve installed in the inlet line would solve the problem.

The unit worked well until one day the electric motor overloaded, tripping while lifting the elevator, causing a jerk. Then a loud bang was heard, followed by the elevator lowering to the bottom, even though the raise button was selected. The passengers were only four or five feet up on their way to the roof when this happened, and luckily no one was hurt.

It was found that the externally accessible inlet filter’s top cover plate had failed and blew oil everywhere.

What caused this to happen, and how could it be resolved?

See the Solution

By Robert Sheaf, CFPAI/AJPP, CFPE, CFPS, CFPECS, CFPMT, CFPMIP, CFPMMH, CFPMIH, CFPMM, CFC Industrial Training

Share this information.

Related Posts

2 thoughts on “Intake Filter in a Mansion Elevator”

  1. Sven Hovland says:

    At low speeds, vane pumps are notorious for faulty performance. It is my assumption (based on the article) that the check valve was placed before the filter in the inlet line.
    If this were the case, and if the the prime mover were to fail while Sol-A was activated, the vanes would allow oil to pass under pressure (from the hanging load) and blow out the inlet filter.
    The pressure switch (should be the DCV killswitch) is placed improperly here.

  2. Terry McCart says:

    In lifting the elevator with load (people in it) a malfunction occurred resulting in an over amperage. Motor shut down (stopped turning), what hydraulic energy that was in the system back pressured back to the tank inlet line (which now has a check in it) was enough to rupture inlet filter housing.

Leave a Reply

Your email address will not be published. Required fields are marked *

Sponsor

Sponsors

Get Our Enews!

Sign up for the FPJ Insider Guide

Sign up to receive fluid power industry news, economic updates, professional development content, and product news delivered right to your inbox.

We will never share your data with a third party without your permission. Adjust your email preferences at any time, and unsubscribing is quick and easy.

Fluid Power Journal Resources