Fluid Power Journal

Inductive Linear Position Sensor

p-alliance

The MHP series linear inductive sensors are designed for installation into the rear end-cap of hydraulic cylinders for operation at pressures up to 5,000 psig. Their 1-inch hex aluminum or stainless steel housing are suitable for mobile hydraulics, factory automation machinery, or oil and gas exploration equipment, and mount to the cylinder with a standard male o-ring port thread. The sensors are based on a proprietary contactless inductive-sensing technology with a short stroke-to-length ratio. They employ a 7-mm diameter probe inserted into an 8-mm (5/16 inch) gun-drilled hole in the cylinder rod to measure position rather than a ring magnet or pot contact spool. They are offered in ranges from 50 to 600 mm (2 to 24 inches) full scale.

Alliance Sensors Group, www.alliancesensors.com

Share this information.

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

Sponsor

Sponsors


Get Our Enews!